DELPHI TL440

Product Details Attribute

Features:

Extensive dimensional and material analysis to ensure the very best compatibility to the Original Equipment (OE) part

Tested alongside the OE part for 250,000 cycles to check braking force, cornering force and suspension travel movement, to ensure the part performs like the OE

Able to withstand temperatures below -40ºC and over 120ºC, helping to ensure they perform even under the harshest conditions

Parts exposed to 720 hours of salt spray for optimum protection against corrosion

Additional cataphoretic coating for greater protection against corrosion and enhanced aesthetics

Attention California Customers - WARNING: This product can expose you to chemicals including Ethylene Thiourea, which is known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.

Alternate/OEM Part Number(s)

OEM / Interchange Numbers: 32111139315, 32111139317

Warranty Information

Warranty Information:Limited Lifetime

CAPA CERTIFIED or NSF CERTIFIED

CAPA Certified or NSF Certified parts bear the seal of independent, third party organizations guaranteeing fitment and quality equal to original equipment. These parts may be required if your insurance company is paying for the repair.

Specifications
Mounting Hardware Included	Yes
Adjustable	Yes
Color	Black
End 1 Gender	Male
End 1 Thread Diameter (MM)	10.0
End 1 Thread Direction	Clockwise (Right)
End 1 Thread Pitch (MM)	1.0
End 2 Gender	Female
End 2 Thread Diameter (MM)	18.0
End 2 Thread Direction	Clockwise (Right)
End 2 Thread Pitch (MM)	1.5
Finish	Cataphoresis
Grease Fitting Included	No
Tie Rod Material	Steel
Type	BENT
Greasable	No
Position(s)	Left
Dust Boot	Yes
Length Stud Center to End (IN)	16.417
Dust Boot Material	Choloroprene Rubber (CR)
Length Stud Center to End (mm)	417.0
End 1 Thread Diameter (IN)	0.394
End 2 Thread Diameter (IN)	0.709