ÜRO PARTS 16146766942

Product Details Attribute

Features:

Efficient impeller design maximizes fuel flow while minimizing current draw

Factory tested for proper operation

Durable high-quality housing materials

Low-resistance motor brushes for durability and efficiency

Precision armature bearings for quiet operation and reduced vibration

Benefits of Purchasing a Fuel Pump & Housing Assembly
Purchasing just the fuel pump is less expensive up-front, but a complete Fuel Pump & Housing Assembly provides added benefits:

Extend Service Life: New strainer(s), hoses, sensors and other components help resolve problems that could be caused by more than just the pump.

Reduce Install Time: Since you don't have to disassemble the housing, which could lead to damage, replacement becomes a simple swap, dramatically reducing installation time.

Save Money: The cost of the assembly is often cheaper than buying the components individually, and means you only have to do the job once.

Prevent Premature Fuel Pump Failure
Preventing premature fuel pump failure is far less expensive and time consuming than continuing to replace the pump. There are three common causes for premature fuel pump failure:

ELECTRICAL ISSUES

Poor electrical connections will mimic symptoms of a failed pump, sometimes resulting in unnecessary replacement. Before replacing the pump:

Use a Fuel System Tester to test pump pressure is within expected range

Use an Electrical Tester to test for bad wiring, burnt or corroded connectors

Check / Replace faulty Fuse(s) and Relay

BEFORE REPLACEMENT

FUEL CONTAMINATION

Dirt, rust or debris in the fuel can clog strainers and stick to internal pump components. When replacing the pump:

Replace Fuel Filter or Fuel Strainer

Empty and clean the tank with Fuel Tank Cleaner

Fill tank with fresh, uncontaminated fuel of appropriate grade

DURING REPLACEMENT

PUMP DAMAGE / OVERHEATING

Running low on gas causes your fuel to heat up quicker, and your pump to work harder. After replacing the pump:

Maintain at least 1/4 tank of fuel and use a Fuel Additive / Conditioner to keep pump cool and lubricated

If vehicle is stored without use, drain tank to prevent pump corrosion from fuel oxidation

AFTER REPLACEMENT

Attention California Customers - WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov

Alternate/OEM Part Number(s)

{Alternate Inventory Numbers: URO-010621}OEM / Interchange Numbers: 16141184276, 16146752499

Warranty Information

Warranty Information:24 Month / Unlimited Mile Limited

CAPA CERTIFIED or NSF CERTIFIED

CAPA Certified or NSF Certified parts bear the seal of independent, third party organizations guaranteeing fitment and quality equal to original equipment. These parts may be required if your insurance company is paying for the repair.

Specifications
Gasket or Seal Included	Yes
Connector Gender	Male
Regulator Included	No
Inlet Type	Barbed
Outlet Type	Barbed
Pump Type	Electric
Wire Harness Included	No
Inlet Outside Diameter	.33 in
Outlet Outside Diameter	.33 in
Fuel Sending Unit Included	Yes
Maximum Pressure	45
Minimum Pressure	5 PSI
Maximum Flow Rating	32