Designed, manufactured and tested in full accordance to requirements for OE products
Perfect finish in every detail such as connections, threads, bolts, mountings and is an exact fit for the vehicle mounting points
Optimized aluminum brazing processes significantly reduce surface impurities caused by residues of brazing pre-treatment agents
Inlet and outlet connections covered by tight closures protecting against impurities and moist absorption during production and storage
An Introduction to Nissens A/C Condensers (Video)
Installation Tips
Old Refrigerant must be removed from the system in accordance with local, state, and federal laws.
Replace the A/C System O-Rings / Seals connected to the A/C Condenser to prevent a Refrigerant leak.
If the new A/C Condenser does not have an integrated drier, replace the A/C Receiver Drier / Accumulator as well. After opening your A/C System, this part becomes saturated with moisture and needs to be replaced.
After installing the new A/C Condenser, evacuate the system for at least 45 minutes to remove any moisture. Make sure it holds vacuum for at least 5 minutes. If it does not, you may have a leak in the system. Find the leaking component and repair or replace it.
Recharge the system with the correct amount and type of Refrigerant as specified in your Owner's Manual.
CAPA Certified or NSF Certified parts bear the seal of independent, third party organizations guaranteeing fitment and quality equal to original equipment. These parts may be required if your insurance company is paying for the repair.
Installation Tips
