DELPHI TA3175

Product Details Attribute

Features:

Extensive dimensional and material analysis to ensure the very best compatibility to the Original Equipment (OE) part

Tested alongside the OE part for 250,000 cycles to check braking force, cornering force and suspension travel movement, to ensure the part performs like the OE

Able to withstand temperatures below -40ºC and over 120ºC, helping to ensure they perform even under the harshest conditions

Parts exposed to 720 hours of salt spray for optimum protection against corrosion

Additional cataphoretic coating for greater protection against corrosion and enhanced aesthetics

Videos

Outer Tie Rod End Replacement

Attention California Customers - WARNING: This product can expose you to chemicals including Ethylene Thiourea, which is known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.

Alternate/OEM Part Number(s)

OEM / Interchange Numbers: 32216767860, 32216782026

Warranty Information

Warranty Information:Limited Lifetime

CAPA CERTIFIED or NSF CERTIFIED

CAPA Certified or NSF Certified parts bear the seal of independent, third party organizations guaranteeing fitment and quality equal to original equipment. These parts may be required if your insurance company is paying for the repair.

Specifications
Adjustable	Yes
Bearing Material	Polyoxymethilen (POM)
Color	Black
Cone Outside Diameter (MM)	18.3
End 1 Gender	Female
End 1 Thread Diameter (MM)	16.0
End 1 Thread Direction	Clockwise (Right)
End 2 Gender	Male
End 2 Thread Diameter (MM)	14.0
End 2 Thread Direction	Clockwise (Right)
End 2 Thread Pitch (MM)	1.5
Finish	Coated
Grade	Standard
Grease Fitting Included	No
Height (MM)	86.5
Housing Material	High Strength Steel
Stud Type	Threaded
Tie Rod Material	Steel
Type	BENT
Width (MM)	45.0
Position(s)	Outer
Pre Greased	Yes
Dust Boot	Yes
Length Stud Center to End (IN)	6.299
Dust Boot Material	Choloroprene Rubber (CR)
Weight (lb)	1.46
Length Stud Center to End (mm)	160.0
End 1 Thread Diameter (IN)	0.63
End 2 Thread Diameter (IN)	0.551