FVP Rotors are designed to meet OE performance criteria.
Features:
- Symmetric vane, split-core castings for uniform heat distribution
- Double disc ground friction surface for optimal performance and service life
- Non-directional finish
Installation Tips
- Always replace Brake Pads and inspect Calipers and Brake Hoses when installing new rotors
- Suspend the caliper from the suspension using a Caliper Hanger to prevent damage to the brake hose
- After removing the old rotor, clean the hub face with a Wire Brush to remove rust buildup and apply Copper Anti Seize to prevent future buildup. Rust or debris on the hub can cause rotor runout and lead to wheel vibration
- Apply Brake Lube to caliper pins, clips, the edges of the brake pad mounting tabs, and the back side of the brake pads to ensure noise free braking. DO NOT apply lube to the friction side of the brake pads
- Use a Caliper Piston Compressor to retract the caliper piston(s) and make room for the new, thicker brake pads
- Open the master cylinder reservoir during piston compression to prevent pressure buildup. Keep an eye on the Brake Fluid level to ensure it does not overflow
- After the job is complete, pump the brake pedal several times to push the caliper piston back up against the pads to ensure proper brake function
Attention California Customers - https://www.p65warnings.ca.gov/Attention California Customers - WARNING: Cancer and Reproductive Harm
Alternate/OEM Part Number(s)
{Alternate Inventory Numbers: 121-34131}
Warranty Information
Warranty Information:Limited Lifetime
CAPA CERTIFIED or NSF CERTIFIED
CAPA Certified or NSF Certified parts bear the seal of independent, third party organizations guaranteeing fitment and quality equal to original equipment. These parts may be required if your insurance company is paying for the repair.
| Specifications |
| Outside Diameter (IN) |
12.992 |
| Outside Diameter (MM) |
330 |
| Solid Or Vented Type Rotor |
Vented |
| Stud/Lug Hole Quantity |
5 |
| Surface Type |
Smooth |
| Discard Thickness (IN) |
0.724 |
| Discard Thickness (MM) |
18.400 |
| Nominal Thickness (IN) |
0.787 |
| Nominal Thickness (MM) |
20 |
| Center Hole Diameter (MM) |
75 |
| Overall Height (MM) |
69.100 |
| Abs Tone Ring Included |
No |
| Mounting Bolt Hole Circle Diameter (IN) |
4.724 |
| Mounting Bolt Hole Circle Diameter (MM) |
120 |
| Overall Height (IN) |
2.720 |
| Disc Mounting |
Floating / DIH |
| Center Hole Diameter (IN) |
2.953 |
| Bearings Included |
No |
| Stud/Lug Hole Diameter (IN) |
0.654 |
| Stud/Lug Hole Diameter (MM) |
16.600 |
