Features:
- Extensive dimensional and material analysis to ensure the very best compatibility to the Original Equipment (OE) part
- Tested alongside the OE part for 250,000 cycles to check braking force, cornering force and suspension travel movement, to ensure the part performs like the OE
- Able to withstand temperatures below -40ºC and over 120ºC, helping to ensure they perform even under the harshest conditions
- Parts exposed to 720 hours of salt spray for optimum protection against corrosion
- Additional cataphoretic coating for greater protection against corrosion and enhanced aesthetics
This adjustable Control Arm allows you to correct the Caster, Camber and/or Toe angles of your suspension, for proper alignment. Adjustable Control Arms are designed for lifted/modified, difficult to align, or siginificantly off spec suspensions.
Attention California Customers - WARNING: This product can expose you to chemicals including Carbon Black, which is known to the State of California to cause cancer. For more information go to www.P65Warnings.ca.gov.
Alternate/OEM Part Number(s)
OEM / Interchange Numbers: 31126863335
Warranty Information
Warranty Information:Limited Lifetime
CAPA CERTIFIED or NSF CERTIFIED
CAPA Certified or NSF Certified parts bear the seal of independent, third party organizations guaranteeing fitment and quality equal to original equipment. These parts may be required if your insurance company is paying for the repair.
| Specifications |
| Mounting Hardware Included |
No |
| Adjustable |
No |
| Grease Fitting Included |
No |
| Ball Joint Mounting Type |
Machined |
| Bushing Material |
Rubber |
| Bushings Included |
Yes |
| Control Arm Color |
Gray |
| Control Arm Material |
Aluminum |
| Control Arm Maximum Length (IN) |
12.283 |
| Control Arm Maximum Length (mm) |
312.0 |
| Control Arm Maximum Width (in) |
3.362 |
| Control Arm Maximum Width (mm) |
85.4 |
| Control Arm Type |
Casting/Forged |
| Greasable |
No |
| Position(s) |
Front Left Upper |
| Pre Greased |
Yes |
| Mounting Hole Diameter (MM) |
1.0 |
| Mounting Hole Diameter (IN) |
0.039 |
